Status: Needs Review

1000 12 Feb 1968

TTY1 is not working properly. T prints
for S. Spacing is sometimes off, etc.

G. Sutherland



At 1100 we de-interleaved the machine and
loaded BLT. Each of the Balun boards that
had bad module tags was put into CORE 3 to determine
if they were still bad. (See note on page
75.) BLT ran for 5 minutes on each board without
errors. Both boards were tapped with a screwdriver
while BLT was running. The section 13 eyelets were resoldered
and the contacts were erased. Both boards are considered good.

The system was put up at 1205 without
the disk
at Karl Pingle's request.

J. Gleason

Notes and Questions

Nobody has written a note for this page yet

Please sign in to write a note for this page